Model #EZBR-0214 | 2.4GHz 802.11bg
Note: This 2.4GHz product is no longer available.
Stay tuned while we work on the EZ-Bridge LT2+ due
to be released in late April 2015.
The EZ-Bridge-LT™ is a high
power outdoor 250mW wireless bridge system operating in the
2.4GHz unlicensed frequency spectrum providing real world
thruput up to 15 Mb/sec. It complies with the 802.11b and g
standards to insure interoperability. The EZ-Bridge-LT™
creates a transparent wireless bridge between two networks
up to 3 miles apart with good line of sight. It supports
multiple MAC addresses and DHCP across the wireless link. It
is the perfect plug and play solution for connecting the
networks in two or more buildings, internet access sharing,
remote video surveillance or remote network access. Multiple
EZ-Bridge-LT™ units can be
connected in a mesh configuration to allow interconnecting
more than two sites.
With its password verification, MAC address
authentication, SSID suppression and advanced WPA
encryption, the system provides the best available wireless
Installation is a snap because of the plug and play
features which have been built into the system. Just install
the antennas and plug in the power supplies. The units will
automatically find their peer and create a secure wireless
network link. If changes to the pre-configured settings are
desired, they can be easily done thru the built-in web
interface from any point on either side of the network.
There are no drivers or software that needs to be loaded to
comes complete with all the electronics that are needed for
a point to point wireless network bridge installation;
including 2 powerful 14dBi antennas with built-in 802.11bg
high power electronics, Bracket Kits which accommodate pole
or wall mounting and Cat5e rated POE (Power Over Ethernet)
Customer needs to supply CAT5 cabling between the power
inserter and the antenna.
TP-POE-15-WP 120/240VAC In, 15V Passive
PoE Out Inserter
EZ2V1 802.11bg 250mW 2.4Ghz Radio Board